Folding Doors

Let yourself be moulded...How does that work with installation of a moulding?

Moulding View Rapid
Moulding View New Generation
Moulding View Eurostar

Measuring and installing a moulding:

Moulding is installed to cover the track at the top of the folding door. It creates a visually clean completion to the door.

One does not always have enough room on both sides of the door to install a moulding. There are also installation situations where installation of one-sided moulding is necessary, (.i.e. division of an alcove or a walk-in closet).

In order to support your planning, we will inform you of the measurements for installation of a folding door or moulding.

In the following photos, we will show you the installation of moulding with the measurements for the track (x) and the moulding (y).

Installation view of both sides of the moulding (Eurostar, President, NewGeneration)
Installation view of both sides of the moulding (Rapid)

What is the minimum depth for the door frame/wall when moulding is to be installed on both sides?

  • Rapid y+x+y: 49+22+49mm = 120mm
  • Eurostar y+x+y: 47+25+47mm = 119mm
  • President y+x+y: 65+28+65mm = 158mm
  • NewGeneration y+x+y: 65+28+65mm = 158mm

 

What is the minimum depth for the door frame/wall when moulding is to be installed on only one side?

  • Eurostar x+y: 25+47mm = 72mm
  • President x+y: 28+65mm = 93mm
  • NewGeneration x+y: 28+65mm = 93mm

 

What is the minimum depth for the door frame/wall when no moulding is to be installed?

  • Rapid x: 22mm
  • Eurostar x: 25mm
  • President x: 28mm
  • NewGeneration x: 28mm

 

Rapid x+y: 22+49mm = 71mm

How to dismantle a folding door

1. Start at the bottom first, on the side where only the rebate profile is mounted.
2. A 1 mm thick, angled stainless steel plate makes a very good tool. Alternatively, use a broad wooden or plastic wedge.
3. Guide the short angled part of the metal strip between the wall and rail. The metal strips should be positioned above or below a clip.
4. Fold the metal strips to the side prying the rails away from the clip, you may need to use pliers to help you do this.
5. Now, you should be able to pull the rail away from the clips using your fingers.
The next step is the rail on the opposite side and the final step, is the top rail.

Sie möchten diese Information mit anderen teilen?

Marley Deutschland

Ich möchte diese Informationen über einen Social Network- oder einen Bookmark-Dienst teilen: